Next.

12 o'clock sharp.

Chen Ya in the workshop had a nutrient in his mouth and continued to work with dark circles under his eyes.

Since the early hours of last night.

Chen Ya has been in retreat...

He had been liver for twelve hours, and finally had a complete exoskeleton out of his liver......

Skeleton.

However, I saw that there was a 'big' shaped skeleton hanging on the armor manufacturing table, and there were four alloy steel rods on each of the limbs of the body, and the joints could be telescopic and twisted left and right.

On the medial side, a groove is cut out in the skeleton, and 360 holes are evenly distributed.

The trench is for the layout of the circuit, and the hole is for the installation of the sensor.

At this moment, Chen Ya is installing spring shock absorbers, and the following is the distribution of thirty-six springs:

Waist: 12 springs

Left arm: 6 springs

Right arm: 6 springs

Legs: 12 springs

……

It can be seen from this.

Chen Ya's shock absorption focuses on the waist and legs, and must be able to withstand heavy pressure.

After being busy.

It was also past one o'clock in the afternoon.

After the shock absorption is done, the next step is to lay out the line.

However, Chen Ya took out the slender power cord, then cut it with needle-nose pliers and stuffed it into the groove in the skeleton of his right arm.

Power cord

It is equivalent to the blood vessels in the human body, and blood is the electric current.

Because there is a matrix power box.

Chen Ya doesn't need to install any circuit boards, and the four skeletons of his right arm also need to arrange a power cable.

The work is not complicated.

When the lines are connected, Chen Ya needs to be spliced with electric tape, and finally all the lines go to the left and right chests of the skeleton.

These two locations.

It is to install the matrix power box.

Just like the left and right lobes of the human body, if there are no lungs, humans will not be able to breathe.

And if the exoskeleton does not have a power box, it will stop working.

About an hour later.

Chen Ya finished laying out the line, then picked up the welding pen and began to install the sensors one by one.

This work...

It's tedious and time-consuming.

After all, 360 capacitive sensors need to be installed.

Fortunately.

Time can be fast-forwarded.

……

Five hours later.

After the sensor was installed, Chen Ya was also tired enough, but he saw the metal skeleton in front of him.

I still can't help but be excited.

However, I saw that the sensors in the skeleton were all tightly embedded in it, and the grooves were also welded to death by Chen Ya, leaving no gaps.

At this moment, Chen Ya also took out two black power boxes.

It's not big.

It's like a cigarette case.

Through his keen eyes, Chen Ya was able to see the circuit board inside and the location of the miniature nuclear battery.

Click! ~

Using a lighter, Chen Ya lit a cigarette to refresh himself, and then opened the two matrix power boxes.

Each installs a miniature nuclear battery.

And then...

It is to put it into the left and right chests of the skeleton and connect all the power cables.

Soon after.

When Chen Ya turned on the power box and turned on the current.

Multiply! ~

The more than 300 sensors in the skeleton lit up one after another, and all of them began to work.

"Give it a try."

Chen Ya said excitedly, and immediately got into the metal skeleton.

Really...

The sensors detected the body and attached it to Chen Ya's skin.

Even ten fingers are attached to the metal bone.

"It's heavy..."

Chen Ya's first reaction was that he could only move his fingers, but when he wanted to move his arms, it seemed to be filled with lead.

That's for sure!

After all, the hydraulic pump has not yet been installed, so there is no power output.

There are also core controllers.

Of course!

The most critical question is...

Just a skeleton, no armor.

Call! ~

But he saw that Chen Ya took a deep breath, puffed out his chest and turned off the power box.

After getting out of the skeleton, Chen Ya couldn't help but say:

"System, give me a copy of the current completion data."

Exoskeleton (skeleton)

Completion: 36%

Weight: 220kg

……

More than 400 pounds.

No wonder it was heavy, Chen Ya then began to assemble the core components.

A metal ball.

This is the core controller of the exoskeleton, something as important as the heart or even the brain.

It is able to distribute power.

And the signal of the sensor, the corresponding processing.

Some are similar to the CPUs of computers, and Chen Ya has to fix them because they are second-hand.

Using a screwdriver, gently disassemble the delicate core controller.

He had previously observed with the eye of fire.

Only one piece of strong magnet needs to be replaced in the controller, and the other parts are fine.

And the strong magnetic...

When Chen Ya was picking up waste for the first time, he happened to collect two pieces, so he took out the sintered aluminum-iron-boron strong magnetism.

Multiply! ~

Start the laser cutting machine and start cutting strong magnetism.

Crackle...

Without paying attention, Chen Ya saw that the laser had shredded the magnet.

"Broken?"

Chen Ya was a little dumbfounded, but fortunately there was a strong magnet, so he could only say seriously:

"You'll have to be careful this time."

A few minutes later.

The magnet was successfully cut, and Chen Ya carefully put it into the core controller, and then welded the metal ball to the heart of the skeleton.

The two power boxes on the left and right naturally need to be connected to the controller.

An hour later.

It's night again.

Chen Ya, who was concentrating on his work, suddenly remembered something.

In the next second, I hurriedly left the workshop, and sure enough, I found the battle angel in the bedroom, and the bag of nutrient solution was about to bottom out.

"I'm sorry, I almost forgot about you."

Chen Ya said with a smile, and then replaced him with a new bag of nutrient solution.

When the nutrient solution was refilled, Chen Ya also returned to the workshop again, but he didn't notice when he turned around.

The mangled body...

The eyelids moved.

Although her eyelids only moved, it showed that she was still conscious.

……

Twelve o'clock in the morning.

Chen Ya worked tirelessly for twenty-four hours.

Even now, he still hasn't stopped, and is knitting a pair of stab-proof gloves using flat circles of zinc steel.

Syllable... Syllable... Syllable...

Not only that, but the armor plates were repeatedly stamped on the manufacturing table.

On the 'X'-shaped shelf on the side, there is also a humanoid skeleton with wings.

Exoskeleton (semi-finished product)

Completion: 70%

Power output: one hundred and twenty tons

Exterior Armor: None

Weight approximately: 352kg

……

Four hydraulics.

Chen Ya installed them all, and behind the two thighs, a medium-sized hydraulic pump was installed in each of them.

As for the large hydraulic pumps...

It's like two black wings that extend down from the back.

At this moment, Chen Ya was knitting stab-proof gloves and couldn't help but say:

"Now it's just the armor."

Exoskeleton armor.

Since there are two words armor, it is natural to have armor protection.

Although not like power armor.

It can protect the whole body, but at least it can protect some vital parts.

If nothing else.

Wait until the armor is processed at the manufacturing table, and it will be finished tomorrow at noon.

But now...

The high-intensity work also made him almost unbearable.

Jingling! ~

But he saw that Chen Ya dropped the woven zinc steel gloves, and then said:

"No, I want to sleep!"

From last night to now, Chen Ya was really sleepy, so he immediately put down the work at hand, and then ran to the second floor to sleep.

Syllable... Syllable...

There is only a manufacturing table left in the workshop, and it is still making noise.

……

[PS: Fourth Update! ] Lao Sha couldn't bear it anymore, and went to bed immediately after correcting the typos and sick sentences, good night everyone]