Compared to the primary chip drawings, the T-1 Terminator robot is more complex and contains an unprecedented amount of information, and it took the apprentice three hours to copy all the drawings and master this "sheet" of drawings.

The apprentice turned off the dual talents and then fell into a severe headache. At this time, all his colleagues had already left in the office of the University, and he was the only one lying on the desk, gasping and patiently, waiting for the end of the sequelae of the Matrix.

Half an hour later, he drank a cup of company coffee and regained his spirits after a little refreshment.

In this half hour, he was not only passively enduring the pain, but also thinking about a question: the future modification direction of the T-1 Terminator robot.

First of all, as stated in the information given by the Nightmare Mark, the T-1 Terminator is a general-purpose robot, but the definition given by the Sepperin Corporation is that it is a war machine, which is reflected in its own 5.56mm caliber small airborne rifle, which has the same caliber and firepower as the M16, and also uses nearly the same bullets, but has a full 100 rounds of ammunition, which can provide good firepower support.

But the apprentice wanted to generalize it.

The first thing to do is to improve its software capabilities and replace the original [Basic Chip] with a more powerful [Primary Chip], so that it can stably receive the electromagnetic signals of the Matrix Child from the Apprentice.

In addition, stronger chips can drive more powerful AI programs, so that even if you don't need an apprentice to control a simple task, it can do simple work on its own driven by the AI program until the task is completed.

The next thing to do is to equip the T-1 Terminator with a functionalized tool, the third drawing: [Prospector - Metal Drill Type I].

[Drawing - Prospector - Metal Drill Type I]

[Introduction: You can use this drawing to create the Prospector-Metal Drill Type 1.] 】

[Drawing category: Equipped equipment.] 】

[Recipe rarity: white.] 】

[Minimum learning conditions: 8 points of intelligence, LV3 of basic knowledge.] 】

…

【Prospector - Metal Drill Type I】

[Rarity: White.] 】

[Durability: 100% (With the use of the drill bit, the durability will continue to be consumed and cannot be repaired; Depending on the material, it also has different durability consumption rates. ）】

[Attack: 10-15 points/sec (increases and decreases with drill speed.] ）】

[Loading effect: Installed on a qualified target mechanical unit, it will gain exploration and mining capacity.] 】

[Evaluation: SCV is ready.] Ahem... I'm sorry, I went to the wrong set. 】

After being equipped with the Prospector-Metal Drill Type I, the T-1 Terminator has the function of collecting minerals, and with the wear-free raw material refiner that comes with the matrix mechanical space, it can produce a steady stream of materials.

Compared to the Junior Chip and the T-1 Terminator, the Prospector-Metal Drill Type I drawing is a "less" informative drawing, and it only took the apprentice 10 minutes to master this scroll. He immediately rushed back to the dormitory and fell asleep.

And on the other side, at the Scorpion Tail nightclub.

After more than half a month of training, Su Hao finally advanced the awakening progress of the [Balanced Shooting] talent to 100%.

At this time, the Nightmare Mark sent a prompt: "You have awakened the talent [Balanced Shooting]." ”

After awakening the balance shot, Su Hao experimented with a number of combat moves that violated human mechanics, and shot during the action, including the skill [Tumbling Shot].

He is now able to maintain a not-so-low hit percentage in an unbalanced position.

Immediately afterwards, after Su Hao completed a [Tumbling Shot], a hint came from the Nightmare Mark:

"It has been detected that you have awakened the talent [Balanced Shooting], you have the ability to shoot when your body is out of balance, the skill [Tumbling Shooting] has been strengthened and adjusted, and the effect of the skill has changed, and the changes are as follows."

"Effect 1: Roll 4 meters in the specified direction → unchanged."

"Effect 2: 'After completing the roll, your next ranged attack will be changed to a Boost Shot.' →' Tumbling and Rolling, the next ranged attack will be changed to Enhanced Shot (increased trajectory speed, accurate fire). That is, you can roll while performing an incredible [Balanced Shot] talent to perform that enhanced shot without aiming, and minimize the adverse effects of tactical rolling on your shooting accuracy (but not immunity). ”

After browsing the data of [Tumbling Shot] after the enhancement adjustment, Su Hao couldn't help but smile. The hard work pays off, and the adjusted [Tumbling Shot] is even more powerful, and it has an incredible metamorphosis effect of "shooting accuracy does not decrease during rolling", which has undoubtedly become another powerful hole card for Su Hao. Su Hao has even begun to design a set of tactics around this skill and the Winged Butterfly.

First of all, use the Folded Wing Butterfly to hit 4 shots as a foreshadowing.

Immediately after, bless the demon strike.

Finally, activate [Tumbling Shot] to trigger the 5th Wing-Fold Flying effect.

Because the tumbling shooting skill itself has a good versatility, it combines dodging, attacking, and all in one. Therefore, when you make a rolling tactical move, the general non-senior contractor, who has not been baptized by multiple nightmare worlds and has no time to reshape a new worldview, will judge that this is a simple rolling dodge action based on past experience, and its purpose is to defend and distance itself, and it is impossible to launch an attack at all.

Based on this judgment, at that moment, it was very likely that he was negligent in his precautions.

And what Su Hao has to do is to bless the demon strike effect during the tumbling process, and then pull the trigger.

No one could have imagined that someone would be able to hit accurately while rolling.

So this shot, the hit rate is about equal to about 100%!

Even a terminator can't resist the combined attack of flying with folded wings + demon strike, let alone a non-senior contractor who hasn't experienced a few nightmare worlds?

With such an unexpected gain, Su Hao was very satisfied. If you encounter a hostile contractor in the future, you will have a surprise hole card.

He closed the skill entry, opened the mission entry, and saw that the two Black Iron team side quests [Resident Evil] and [Ambition of the Ministry of Machinery] were still being executed.

The mission objectives of the two missions are very similar, which is to hand over items that meet the requirements of the mission to Loew, the director of the mechanical department, and alpha of the biochemical engineering department, respectively. The apprentice only handed over the mechanical left arm and the human skin mask, and the mechanical left lower limb and the onomatopoeia articulator were not handed in. Only by handing over all the chips can the task be overfulfilled and thus get a higher task completion evaluation.

Since the apprentice has not been handed over in full, it means that he will have to stay here for a while longer.

It's okay to do left and right, but do some side hustles. Since he had a liquid memory metal mask in his hand, Su Hao didn't mind disguising himself as a different face to take out a few members of the Antelope Gang, or even the outdated Terminator, to make some extra money.