After taking a nap at noon, after Chengxin got up, Wen Xinqiang and the others had already gone to work in the field.

However, the people in the dormitory have not finished, and Yang Kuan and Zhou Yong have not left.

"I was about to call you, everything is ready."

Seeing Cheng Xin come out of the room, Zhou Yong, who was coming over to his tea.

"I forgot to set the alarm clock, I almost forgot it." Cheng Xin explained.

"Well, then our excavator is over, and the pickup truck is handed over to you."

After resting money just now, Chengxin temporarily arranged a little bit for the excavator trio who were okay for the time being, that is, to open a drainage outlet in the farm.

The small plots of land in the whole farm, except for the hundreds of acres of land that were milled at the beginning, the other plots, each piece of land has left unmilled ridges.

Before planting crops on this farm, it must be soaked in water for a period of time.

It is also an invasion bubble that drains water while filling water.

Therefore, in each piece of land, a 60-centimeter-deep water inlet had to be dug at the edge of the aqueduct.

On the side of the drainage canal, in order to make the effect of acid and salt discharge better, at least 5678 drainage outlets must be dug on each field ridge about 50 meters wide.

After digging three excavators were launched to the ground, Chengxin also got into the pickup truck.

"Wait a minute, I'll help too."

Chengxin hadn't started the fire yet, and the uncle came out of the house.

He changed the oil on the last excavator this morning, and there was no work for the next few days.

Chengxin didn't speak, twisted the key to light the fire, and after the uncle got into the car, he kicked the accelerator and chased the excavator.

By the time he got to the ground, the excavator had already been caught up by him, and he was far behind.

When I came to the drainage canal, the ground was all seventy or eighty centimeters of soft soil, and the field ridge was only about one meter wide.

So, he went straight up the slope on the side of the drainage canal and brought the pickup truck to the drainage canal.

Wait, isn't the land on this side of the farm only about 60 centimeters plowed? Where did the seventy or eighty centimeters of soft soil come from?

This brings us to the issue of density.

Anyway, the 60 centimeters of land is 70 or 80 centimeters thick, and in some places the quota is 90.

Three excavators, one digging the water inlet on the side of the aqueduct.

Although the field is two or three meters wide, just dig one, so leave one over there.

The two excavators came to the side of the drainage canal, but they didn't come down, they were directly in the ground, and the thickness of this side had no effect on the two big guys.

The only effect is to press the soft granular soil a little tighter.

Without digging the drainage outlet at the first time, the two excavators started the work of digging the soil first.

After the milling of this land, it has never been moved, and the particles of soil are all next to the fields.

Therefore, the first thing the excavator does is to dig the soil, dig the soil next to the ridge, and clear out an open area more than one meter wide and fifty meters long for water seepage.

Chengxin's uncle and nephew were not idle.

A diesel cutter was lifted from the pickup truck and began to cut on the ridge.

After the drainage has been excavated, an adjustable water baffle will have to be installed, so both sides of the drain must be smooth.

If the excavator is allowed to dry directly with a crushing hammer, with the hardness of this land, it is a large piece, and the uniformity of both sides of the drainage outlet cannot be guaranteed at all.

The cutter was lifted down and put away, and as the uncle pulled hard, the diesel engine sounded.

Chengxin tinkered twice, and the blade of the cutting machine spun rapidly.

"Uncle, help me adjust the depth."

The first time he operated this thing, Chengxin was also quite nervous, and his hands directly supported the slightly vibrating cutting machine.

Just in front of the hands of Tai, there is a steering wheel with a diameter of more than ten centimeters, and if you want to increase the depth of the cut, you can turn this steering wheel.

As the uncle turned the small steering wheel with one hand, the cutter head on the edge of the cutter cut into the dirt little by little.

This thing is trivial to cut stones and concrete, and it is even easier to cut this hard soil.

When the blades were thirty or forty centimeters deep into the ground, the cutting machine did not make any special sound.

This cutting machine is specially selected, so the cutting depth can reach more than 70 centimeters.

It is enough to cut these sixty centimeters of field.

When the blade reaches depth, Chengxin slowly pushes the cutting machine.

It took five minutes to complete a cutting line about 60 centimeters deep and a meter long.

Raising the cutterhead, after the uncle measured the distance with a tape measure, the uncle and nephew began to cut again.

Two cutting lines were done at one place, and the uncle and nephew moved seven or eight meters before cutting at the time.

I cut more, my proficiency has risen, and I don't have to worry so much.

Speaking of which, when cutting the first one, Chengxin was also afraid that the speed of the knife would be too fast and the blade would be stuck.

This doesn't count, the most worrying thing is that if the blade is broken, it will fly out and hurt people.

An hour later, the uncle and nephew managed to get the first field.

When they reached the second block, the two excavators also began to work on the ridge.

After more than four hours of drying in the afternoon, the uncle and nephew cut the drains of ten plots.

Fortunately, the excavator also needs to clear the soil on the edge of the field. Otherwise, at this speed, the uncle and nephew would not be able to win two big guys at all.

When he slept at night, Chengxin felt that his hands were still vibrating.

The next day was cloudy, and in one day, the uncle and nephew were faster, and they completed the cutting line of thirty fields in one day.

On the afternoon of the third day, the uncle and nephew pulled the cutter and went to another drainage canal three kilometers away.

On the fourth day, Chengxin was laid off and replaced.

It's been two and a half days, and now Wen Xinqiang and they have finished milling the last few pieces of land, so he gave way.

However, he was not idle, and the remaining three people came to dig the drain and bulk the water baffle.

This thing is like the gate of a small reservoir, a frame with nothing but the bottom, and a steel plate in the middle that can be adjusted up and down.

The top rebar is a steel plate that rises as long as you turn it.

In the blink of an eye, it was two and a half days, and before noon, the drainage outlets of more than 100 plots of land were all completed, and the water baffles were installed.

After lunch, the group of people started to get busy again.

This time, the pumping machine was installed.

This more than 10,000 acres of land needs a lot of water, and the pumps needed are all big guys.

Two ten-inch large electric centrifugal pumps, these two big guys spent more than 300,000 yuan.

It's a little more expensive, but the benefits of being expensive are not?

These two pumps, under the condition of ensuring that there is no shortage of butter and cooling oil, have nothing to do without stopping for a month or two.

The only downside is that the electricity is more powerful.

In the afternoon of the next day, with the installation of the stainless steel pumping pipe that went deep into the lake, as Chengxin's thumb pressed the start button, the two pumping machines immediately made a roaring sound.

The ground is a bit big, and in order to fill it all up faster, both machines start at the same time.

When the water is full, turn off one and use a pump to maintain the water level.

Fortunately, the aqueduct is more than one meter wide and about the same depth, and if it is a little smaller, it will not be able to carry the pumping water of two ten-inch pumps.

After everyone pumped water from the pumps, they went to both sides of the aqueduct.

You have to watch for a while, if the water in the canal can't flow into the ground in time, then you should turn off one of the pumping machines, don't let the water overflow the canal, it's a waste.

In the afternoon and half a day, no flooding was found on either side of the aqueduct, and it seems that the water injection port can absorb the water of the two pumps.

Since it is not flooded, then don't worry about him, with an area of more than 10,000 acres, let him smoke it for two days first.