Hans went back to his lodgings, took out the metal that even Otto couldn't forge, and tried it himself.

There is also a "wind weld" on his left armguard, which was originally used as a weapon, but now it is going to be used as a tool, and he uses wind welding to cut it on metal, although it is very difficult, but it can barely be cut, although it can be cut, but it is obviously not possible to use wind welding to forge, unless he is just forging some small items.

As he looked at the gauntlet, he remembered what Amy had said, to use more alteration magic. Then he began to try to prolong the flames that erupted from the gauntlet!

The first was to increase the forward flow of air, and it was found that it didn't help much, and the flames were still extinguished in a very short distance. He thought that it was a matter of fuel, and then he tried to use air flow while condensing the fire liliang, but in the end he could only extend the flame a little, and in the end it was better to condense a fire-breathing magic directly outside.

Hans was very unwilling, he kept trying other methods, but he tried to run out of mana again. He thought as he regained his mana, and tried many times, but he hadn't tried the water magic that he was best at. I remember that I used to decompose water beads into oxygen and hydrogen, but I wonder if it can be used here?

After his mana was restored, Hans prepared to do another experiment, condensing a very thin chain of water in front of the flamethrower, then turning on the flamethrower and blowing it forward with wind magic, which startled him!

Watching the water chain evaporate directly after being burned into combustible hydrogen and accelerant oxygen, the entire water chain was directly burned under the effect of wind magic. But this magic is not lethal, and he has to find a way to keep breathing fire.

So Hans tried to condense the water chain in the path, and at the same time used wind magic to speed up the flow of air, which was sure to make the fire-breathing last a little longer. However, due to the fact that he still had to use plastic magic, his mana could not be sustained for too long, but it was better to say that a new type of magic was finally developed, albeit with the help of tools.

Then Hans thought, since the Spitfire can be extended, what about the electric shock? The two ends of the electric shocker must be connected to the conductor, if it is extended with a water chain, can it be electric shock to the target in front of it?

He placed a piece of metal two meters away, and then began to condense a water chain at each of the two contacts and metal of the shocker, activating the shocker!

Suddenly, with a "bang", the water chain exploded, and Hans also took a few steps back, and sat on the ground unsteadily, and then looked at the fragment, it was only a little scorched, this is considered a success? No, it seems that the water chain does not last long under the current, so the damage to the target is very limited.

Moreover, the explosion just now took another toll on Hans's injuries, and he hurriedly stabilized it with healing, and it took a while to recover with a sigh of relief. It seems that these potentially dangerous attempts will only be made when precautions are taken.

Hans calmed down, and then it occurred to him that he had always underestimated water magic, and in some certain environments, the power of water should not be underestimated. Although Dengeki Shiyan was a failure, he finally learned a new method.

Hans suddenly remembered that what if copper was used as a conductor instead? Although it was not possible to condense copper with plastic magic, it was possible to control copper wires with alteration magic.

So he immediately went to the trading market to exchange some copper coins, and at the same time bought a hen, and went back to his residence to study it. Since copper itself is easy to change, it is not difficult to change, Hans uses magic to create two copper wires, hang them on two electrodes, and then try to control the copper wires to attack the target.

At first, it was difficult to control, but then Hans came up with a way to tie a nail to the other end of the copper wire, and directly control the nail so that the nail could carry the copper wire, which was much easier. However, the copper wire should not be too long, at most about two meters, and if it is long, it will be ugly to control and easy to make mistakes.

Ready, it seemed that the hen was about to suffer, and Hans brought a table to block it this time, and then reached out to control the nail to be inserted into the hen, and then immediately activated the shocker. I saw that the hen caught fire and burned in an instant under the action of the electric current, but Hans's copper wire also burned out at the same time! Finally, a feasible solution was found, as long as the size of the copper wire was controlled to cope with the current.

But unfortunately, a single shock consumes almost 30% of the power, and this arm guard is charged by human movement, and it seems that this experiment is in a hurry.

Hans was not too anxious either, and rested at home for the day.

......

The next morning, Hans went to Otto, and he said, "I have a way to cut the metal materials I brought back yesterday, but they still can't be forged, I wonder if they can be used?"

Otto looked at Hans with wide eyes, and said, "Do you have a way to cut it? I haven't been able to do that for a long time." ”

Hans asked, "Don't worry, I'm sorry to trouble you." I also found out yesterday that it can be cut. ”

Otto said: "You said that you can cut, I remember that yesterday there were some materials that were relatively large, so combined with the existing materials that can be used for forging, maybe you can really make an armor." Because your materials are very light, it is very suitable for making armor, at least the front and rear armor can be used. You go back and give me all the materials, and then I think about how to design it and then tell you, and I'll draw the lines on the materials to be cut, and then you can cut them and bring them back. ”

Hans also thought it was good news, so he went back to bring the materials back to Otto, and went back to experiment with the electric shocker, and of course another hen was going to suffer......

Another day passed, and Hans approached Otto, who seemed to have not slept all night, but his expression was very excited.

He said to Hans: "I have already figured out how to make your armor, it is a composite armor of steel plate and chain, these are really magical materials, I dare to guarantee that after making it, except for the magic gold armor of the Prince of Wales, this is the strongest armor in the Kingdom of France!"

As for the cost of the construction, Otto was very negotiable, as long as he gave him the rest of the materials, he could not charge at all, Hans thought about it and felt that it didn't matter, so he also agreed to the deal, and then returned to the residence with the metal that needed to be cut.

However, when Hans began to cut, he found that there were really a lot of things to cut, and the power of the arm guards was simply not enough, and it seemed that this task would be divided into many days to complete, so he had to hand it over to Otto one by one, anyway, it would take time for Otto to build other equipment.

*Warmly celebrate the breakthrough of 100,000 words in "The Legend of the Red Wolf", thank you for your continued support and encouragement. More exciting content is coming soon, so please look forward to it.