There is no way to safely control the placement of the frame by manpower alone, so Xu Yi made up his mind early on and wanted to rely on the power of machinery to help him complete this almost impossible task...... After reading the latest and most complete novel, Xu Yi directly removed the zipper crane from the slide rail and fixed it to the top of the shelf.

The weight limit of his zipper crane is 8,000 catties, even if it really relies on this crane to lift the weight of two or three thousand catties, it is a breeze, not to mention that as long as it is hung at the far end, it can withstand part of the tension near the side of the shelf, and in the end, the tension on the crane is not so large, so Xu Yi is not worried about the problem that the crane can't pull the shelf.

Of course, although the crane can lift the frame easily, it can only pull the frame by relying on it, but it also bears a lot of pressure and tension in the downward and forward directions. It is difficult to guarantee that this shelf will not slide forward with just a few steel pipes, let alone that it will not tilt forward or even collapse directly, so Xu Yi's previous work is not completely useless.

The main purpose of the wood cube buried in the ground is to prevent the skeleton from sliding towards the crane when the frame is put down, and it can also be used as scaffolding when the board is laid on top when necessary.

In the same way, because of the influence of the force angle, even if only the bottom surface is nailed, when the wooden frame is lowered, the downward tension plus the weight of the shelf itself, it is difficult to rely on a few steel pipes to ensure that they will not be pressed into the soil below.

The uneven force on the front and back will inevitably lead to the steel pipe that makes up the frame to be easily bent forward, or even lose balance and fall over because of excessive force.

To avoid such a tragedy raw. Xu Yi has also taken some corresponding measures.

In addition to the wooden planks under the steel pipes at the bottom of the shelves to reduce the pressure of the steel pipes on the ground. Xu Yi also inserted all the ends of the steel pipes near the direction of the wooden stacks under the adjacent wooden stacks. In this way, unless the steel pipe can be bent or the pile of wood can be pried up, otherwise the shelf will definitely not be able to turn over.

Similarly, in order to increase the middle part of the frame of the shelf, in addition to leaving a steel pipe for backup, all the excess steel pipes and buckles are added to the shelf, and pulled diagonally to avoid accidents such as bending the steel pipe and even breaking the buckle due to excessive tension.

As the old saying goes, be careful to sail a ship of ten thousand years.

After all, the weight of thousands of catties, if there is really any accident in the assembly process. It's likely that you'll have to slap yourself under this board and smash it out. Xu Yi didn't want to try whether his skills had increased so much that he could break through this board and break this sleeper and drill out of it. This is equivalent to the feeling of the floor slab collapsing and smashing on the head during the earthquake, who knows if such a situation will occur, and whether he will have the life to get out of the space?

I'm afraid that this is called heaven and earth should not be called spiritual, Xu Yi doesn't want to be careful all the time, but in the end he ended up with such a result.

Looking at the gaps on the shelves, Xu Yiyou moved wet wood from the top of the wooden stack and stuffed it inside. In this way, the weight of the shelf itself can be increased, and it can also play a certain role in reinforcing the shelf.

Until the space on the shelves is full. Xu Yi reached out and pushed the shelf from the side.

I saw the shelf standing firmly on the ground, not moving at all. Xu Yi took the broom with confidence and cleaned the ground near the stake. After the floating soil was cleaned up, Xu Yi took some wooden planks and laid them along the wooden squares for a long time, and then began the formal assembly work.

Xu Yi moved the long side of a wooden frame, looked in the direction, and then placed it on the ground. Flip it over a little more so that one side of it is next to the wooden squares, and the opening of the dovetail groove is also facing outwards and upwards, and then the short sides of the two sides of the wooden frame are moved over, and after being aligned in the same direction, they are loosely stuck on the bottom edge, and then fastened to the adjacent wooden squares with ropes, so that they do not fall down.

After the two sides were arranged, Xu Yi adjusted the direction of the remaining side, moved it directly to the top of the wooden square, and then climbed to the top of the shelf to combine the mortise and tenon joints at both ends with the two sides.

After the wooden frame was assembled, Xu Yi knocked on the wooden frame hard to make sure that this side would not slip off the two plugs, so Xu Yi climbed down from the shelf, stepped on the ladder to knock the mortise and tenon joints on both sides tightly, and assembled the frame.

Of course, for the previous reasons, the two sides could not be fixed now, Xu Yi just knocked the upper and lower directions tightly, and then stopped temporarily, ready to install those sleepers and cross braces. When the sleepers and cross braces are all installed, the two short sides have to be removed and those cross braces can be reassembled on top of the skeleton.

After all, this is a vertical installation, and it is impossible to assemble the sleepers and cross braces together on the frame like on flat ground.

Xu Yi picked up a sleeper near the edge, put it upright on the frame, and placed it on top of the frame. The dovetail tenon at both ends of the sleeper just happened to be in the corresponding dovetail groove, and it was not inlaid in, and then Xu Yi let go of the card slots on the sleeper, and then used a rope to simply fix it with the adjacent wooden square, so as to avoid the sleeper falling off the frame during the subsequent installation process.

After that, it's simpler.

Xu Yi took the sleeper that was next to it, and then took the horizontal braces in between. Put the sleepers against the wooden frame as well, and then clamp those cross braces with the grooves corresponding to the two sleepers, and the sleepers can just be stuck on the corresponding grooves on the frame.

After the latter sleeper was also simply fixed with a rope, Xu Yi took a hammer and gently tapped it on the dovetail tenon at both ends of the sleeper installed before, so that it was embedded a little in the dovetail groove of the frame, so that it was tightly combined with the frame and could better bear the weight and thrust.

In this way, you can avoid the whole skeleton slipping off the frame after installation, which can be wasted.

Similarly, after the third sleeper was installed and simply fixed, Xu Yi removed the rope from the first sleeper, and then knocked it and the second sleeper into the dovetail groove a little more.

And so on and so forth. Wait until the last sleeper is installed. Already most of the sleepers have been completely hammered into the dovetail groove.

After all, it was tossing up and down. Xu Yi had already been tossed out of sweat, but now was not the time to rest, Xu Yi simply wiped the sweat, and then climbed up and down the ground, knocking all the tenons of the remaining sleepers tight.

Only then did Xu Yi remove the short sides on both sides of the frame, and after installing the corresponding cross braces as well, he assembled them and determined the leveling of the entire skeleton. Xu Yi directly nailed the small holes in the four corners of the frame with wooden strips, and the entire skeleton was really completed.

In order to make the whole skeleton more tightly combined, Xu Yi took a chisel and a hammer, split it vertically at both ends of each sleeper, chiseled a wooden crack on it, and then used thin wood chips to cut into pieces of narrow wooden wedges and inlay them in this gap, directly reinforcing the mortise and tenon joint.

After cleaning up the part of the wooden wedge that is higher than the sleeper, Xu Yi took the trapezoidal wooden block with the same shape as the tenon and inlaid it in the dovetail groove, and filled in the remaining two-centimeter groove on the outside of the sleeper.

Then trim off the part of the wooden block that is higher than the molybdenum ore, and Xu Yi took the piece and the width of the wooden frame was the same. Planks with a thickness of exactly one centimeter. After aligning the planks with the frame, Xu Yi directly nailed them to the frame with a nail gun. I sealed the side facing the outside.

In the same way, the two untrimmed parts on the sides are nailed to a layer of the same one-centimeter board, and then the horizontal braces are simply reinforced with a nail gun, so that the whole skeleton is completely assembled.

The next thing was much simpler, Xu Yi went directly to the top of the shelf, held the steel pipe left before and put it on the outside of the skeleton, and tied the two ends directly to the frame close to the top. In order to prevent the steel pipe from moving, Xu Yi also fixed it with ropes on the sleepers that the steel pipe passed. Then use the wire rope to wear it inside the steel pipe, put the two ends left on the outside together, and firmly clamp it with a buckle, Xu Yi hung the wire rope on the hook on the crane and fixed it directly with the rope to save it from slipping out.

After that, Xu Yi took the board and put it close to the lower frame, and nailed them to the sleeper one by one from bottom to top.

It's a bit trivial, but it's not very technical at all.

In order to avoid the joint of each piece of wood in one place, in addition to making the joint of each piece of wood in the middle of the sleeper, Xu Yi also nailed a board to the end, and then started from that end to nail the side frame backwards, so that the seams were all staggered.

Nailed until the sleeper was tied to the place where the rope was tied, Xu Yi stopped, moved the rope a little higher, and then nailed it over, until it was difficult to nail it up again when he stood on the ground and raised his hand, Xu Yi untied all the ropes, climbed to the top of the shelf and pulled the jack, and tightened the wire rope to the right length.

Now it's time to tilt the skeleton a little bit, Xu Yi reached out and grabbed the shelf, leaned his back against the sleeper on the shelf, pressed his feet on a cross brace on the shelf, and kicked hard, feeling the shelf behind him leaning outward a little bit.

When the center of gravity of the shelf is shifted to the outside of the bottom edge, the shelf falls straight down.

Xu Yi felt that there was no air behind him, and he saw that the hook in front of the crane shook violently, directly pulling the wire rope, and the wooden frame was pulled and finally stopped.

After feeling that there was no problem, Xu Yi breathed a sigh of relief, directly pulled the zipper of the crane, and put the front hook out, so that the wooden frame without a nailed board continued to descend.

When the front work area was lowered to a suitable height, Xu Yi stopped, and then went to nail the board to the wooden frame, and when the working surface was too high, he put the crane down.

After repeating this, Xu Yi finally nailed the bottom surface to the front, and only stopped where the steel pipe was tied. (To be continued......)

PS: I can't update it in October because of well-known reasons, but September is too busy, well, it's an accident. If possible, try to do as much as I can this month when I'm done with all the mess at the end of the year.

It's hard to keep updating every day this week.,It's a month off.,Plus the unit review just passed guò yesterday.,There must be a lot of things that the unit has pressed for a year.,So the update may be difficult to guarantee.,I'm sorry.。

As for saying that the eunuch is unfinished, I really won't do this, after all, it's rare to write a book, and you have to start and finish well - this is also the foundation of our life.

Well, it's slow enough to think about it, this store has been open for more than a year, hehe......

Thank you for your support during my absence, thank you.

Tips: The new domain name "biquge.info" has been launched by Biquge, and the original domain name is about to be discontinued. Please tell each other, thank you!